Cannot drive I2C Oled :(

[timc]

Personally I would not alternate different data types in a big character table because you want to make it as simple and small as possible. From the PBP manual it says: "Lookup2 generates code that is about 3 times larger then Lookup."
So I went back to Lookup. The only other reason that you might use Lookup2 is because it can address 1024 values. The new manual for V3 says Lookup can address 1024 values but it failed after "S" and before it reached "T" which is exactly 256 values.

Me thinks the V3.0.8 compiler has a bug!

[timc]

I posted a full demo of a SSD1306 add-in over on the code example forum. elcrcp I think this is what you were asking for earlier.
Best part is you can start to use it like a regular LCD with data from other devices and formatted output.

http://www.picbasic.co.uk/forum/showthread.php?t=20179

TimC

[elcrcp]

Yes TimC that is my answer =)
By the way, I tried your init suggestion and it's fine (I didn't know that upper limit of contrast was 7F) then I wanted to see your include file and sample code (good job you did there ) but I couldn't make it work don't know why, I'll examine them detailed later but they are definetly very useful and easy to work with.

[timc]

The Contrast Init line should read
Set contrast FROM $01 to $FF NOT Set contrast to $01 to $FF.
Therefore $FF is the upper limit.

Good luck