Sending text to GLCD using BV4511 interface

[Scampy]

Thanks for the test code. I've changed the parts to suit the PIC and Easypic board and compiled it without error.

I am currently working on a project and have a breadboard with an DS1307 RTC chip connected to the EasyPIC5 board via the expansion port. On running the application it reported one device found and it's default address that matched that used in the project code. I then connected the GLCD and double checked the wires were correctly connected to the i2C bus. Upon running the PIC again (twice to be sure) I got the attached results !!

I have no idea what's happening... my guess it that the board contains firmware that will only respond to serial codes or similar and not a normal i2c protocol - Resetting the board using the jumper wire has had no affect...