Debug/Serout/Serout2 - please, need advice ...

[fratello]

Thanks for reply !
I use simple link PIC to PC (GPIO.5 connected to DB9 - pin 2).
I tried DEBUG command too ... with same results ...
Of course I added in my program :

 DEFINE DEBUG_REG GPIO          'Set Debugin pin por
 DEFINE DEBUG_BIT 5             'Set Debug pin bit
 DEFINE DEBUG_BAUD 2400         'Set Debug baud rate
 DEFINE DEBUG_MODE 0            'Set Debug mode: 0=true,1=inverted

My schematic is based on Mr.GioppY "serial voltmeter" (http://www.picbasic.co.uk/forum/showthread.php?t=7182) with modification for my purpose ...
Mr.GioppY use, in his program :

debug  dec TmpW dig 4,dec TmpW dig 3,",",dec TmpW dig 2,Cr,Lf

but with VB program.
First I tried "Debug DEC Advalue, 13, 10" , but I have same results in RealTerm.