|
Re: Pic10F202 Master clear will not turn off.
not that wrong ...Originally Posted by Elusiveinc
http://www.picbasic.co.uk/forum/show...8753#post18753
yess ... that's short !
seen ?
from here : http://www.picbasic.co.uk/forum/show...1725#post71725In PBP, the 10F202 uses PBPPIC12.RAM, which requests 19 bytes of RAM for PBP system use. The 10F200 only has 16 total bytes of RAM available so it looks like it is a no go with PBP unless you want to do a lot of custom stuff.
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
|
Re: Pic10F202 Master clear will not turn off.
Have you looked into a 12Fseries instead of using the 10F202?
Quite a bit of functionality added for just a few cents difference.
Something like the 12F1571?
12F1571-I/P (8pin Dip) .64 cents per unit Qty 1-25
1KWord Flash, 128Bytes RAM, (6) I/O Ports, (2/4) 8-Bit/16-Bit Timers, (1) Comparator, (3) 16-Bit PWM, (4) 10-Bit ADC ch
10F202-I/P (8pin Dip) .57 cents per unit Qty 1-25
512W Flash, 24Bytes Ram, (4) I/O Ports, (1) 8-Bit timer
Regards,
TABSoft
|
Re: Pic10F202 Master clear will not turn off.
Elusiveinc,
This is what I use for a program to operate a third tail light. It uses a 10F222.
asm
__CONFIG _MCLRE_OFF & _CP_OFF & _WDT_OFF & _IOFSCS_4MHZ
movwf OSCCAL ; load factory osccal value at start-up
bcf OSCCAL,0 ; Set GP2 as I/O pin
ENDASM
Dave Purola,
N8NTA
EN82fn
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks