Re: MRF90XAM9A interfacing help
Crossed posts.....
I changed the Register 00 to $2A and it still reports PLL bit as '0'.
BUT, on page 30 of the DS it shows $00 for VTune to be determined by the inductors - not $01 ???
Forget it, I was still reading the 140 page DS not the 36 page one for the module.
I get it.....
The RESET pin is tied to an IO on the proc, it is currently held low, but the module datasheet says in a high impedance state.
Wonder if this is my issue? Should I let it float?
Last edited by ecoli-557; - 17th February 2015 at 00:36.
"If we knew what we were doing, it wouldn't be called research"
- Albert Einstein
Bookmarks