It's been a while since I programmed in PicBasic. I would like to get back into it. But I am struggling with the simplest of task.....blinking an LED. Spent 3 hours trying to figure out what I am missing. Maybe someone can show this old newbie what I am missing.
Code:
' PIC18F24K50 Configuration Bit Settings
#config
CONFIG FOSC=INTOSCIO
CONFIG PLLSEL=PLL3X
CONFIG CFGPLLEN=ON
CONFIG CPUDIV=NOCLKDIV
CONFIG LS48MHZ=SYS48X8
CONFIG IESO=OFF
CONFIG FCMEN=ON
CONFIG PCLKEN=ON
CONFIG BOREN=OFF
CONFIG nPWRTEN=OFF
CONFIG nLPBOR=OFF
CONFIG BORV=220
CONFIG WDTPS=32768
CONFIG WDTEN=OFF
CONFIG MCLRE=OFF
CONFIG SDOMX=RC7
CONFIG T3CMX=RC0
CONFIG DEBUG=OFF
CONFIG STVREN=ON
CONFIG ICPRT=OFF
CONFIG XINST=OFF
CONFIG LVP=OFF
#ENDCONFIG
DEFINE OSC 48
OSCTUNE = %10000000 '3X PLL ratio mode selected
OSCCON = %01110000 'Switch to 16MHz HFINTOSC
OSCCON2 = %00010000 'Enable PLL
'*********************** PORT CONFIG ****************************
TRISA = 0 'porta direction 0=OUTPUT 1=INPUT
PORTA = 0 'porta preset
ANSELA = 0
'****************************************************************
'******************* MAIN PROGRAM ************************
'****************************************************************
while 1
low PORTA.5
PAUSE 500
high PORTA.5
pause 500
WEND
end
Bookmarks