i would love to migrate , to another platform but the amount of work /time required its just not a road i want to go down , i need to finish this project , and i am very close for stage i want to be at ,

i need to add few other features , which will exceed 128k ( its currently at 110k ) and adding another chip appears to be the easiest way to use my existing coding/ knowlage and with what is written so far for the support code i have .


hendrich i am doing block diagram as its has quite a few moduals you would imagine

adding a 2nd chip although its pain , as the interface support to access and use hardware on both cpus and the common interface varables then transfer to the other cpu as needed , notification via status word for use between cpus for interrupt control notification ,etc etc

it is bit scarry at this point on the amount of extra work needed , to gain about 40k of program space , but that far less than learning a new scripting langage and new plateform i think.

ill post a block diagram of the key hardware interfaces.

I am trying to get the code smaller ,but tring to find 40k is just not likely

cheers'

sheldon