New PBP3 user

[muddy0409]

Did have 2 versions of MPLAB.exe, 5.49 installed feb 2013 and 5.03 inst mar 2006

deleted the early one and reran the mplab setup then checked the close thing in PBP3 assembler edit.
ALL NOW CORRECT

So should I delete the full MPASM stuff and install the latest? But I am rather inclined to now leave well enough alone. Ya think?

[HenrikOlsson]

Great!
Personally I'd leave it alone until I see a specific reason (like lack of support for a specific chip) for updating.
I don't know if 5.49 even might BE the latest.

/Henrik.

[muddy0409]

Boy o boy.
I finally decided to do something that someone agrees with.
Yep, I will leave well enough alone. I only use the smaller 16F and some 16C chips that all appear to be supported.
Thank you so much for listening and helping.
If I can be any help to you in future, please do not hesitate to contact me. That should give us both something to laugh about??

Thanks again.

[Acetronics2]

So should I delete the full MPASM stuff and install the latest? But I am rather inclined to now leave well enough alone. Ya think?

Hi, Peter

as the latest 8.92 MPLAB IDE is working pretty fine ...

why not install it "as is " ... ???

That would avoid any surprise in the future ...
and you wouldn't have to ask yourself if the "xxxxxer" version is the correct one or not ...

Just my two cents ...

Alain

[muddy0409]

I think I will leave well enough alone.
Thanks Alain.