PIC conducting signal current when off

[ardhuru]

I've seen circuits where this is done deliberately, with power being supplied thru' an i/o pin, rather than Vdd.

Any idea what the advantage is? Lower power consumption?

[HenrikOlsson]

Hi,
I don't see any advantage with that, only problems. The 16F877 datasheet specifies a maximum clamp current of +/-20mA. If your circuit pulls more than that you're in trouble.
Ie, you have a couple of LEDs on the output of the PIC, each pulling 10mA. You're then powering up the PIC by backfeeding current into Vdd thru a I/O pin, the PIC powers up, start running the program, turns on 4 LEDs. Current comsumption is now ~40mA and all that needs to go thru the I/O pin and its protection diode which, as the datasheet specifies, is rated for max 20mA.

Do you have a link to a schematic where this has been done deliberately, perhaps we could figure out why when we see it.

/Henrik.

[ardhuru]

I wish I could remember!

It was a long time ago, and at that time it was not of much interest to me, so I did not bookmark it.

Anyway, spent some time googling for that information (without remembering anything about it, like the purpose, chip used and so on), quite unsuccessfully, and then found something not quite in the line of discussion, but interesting all the same.

http://www.t4f.org/projects/open-rfi...rfid-emulator/

As also, another interesting page, not quite connected with the discussion.

http://www.solarink.net/2014/02/a-pi...-one-volt.html

Anand

[Jerson]

Hi Anand

Those links are very nice and interesting. Thanks for sharing them.

Regards