|
Re: 18F14K50, PORT C as outputs
Mmm... I tried this but it still doesn't work!
Code:REFCON0=0 REFCON1=0 ADCON1=0 ADCON2=0 ANSEL =0 ANSELH=0 CM1CON0=0 CM2CON0=0 SRCON0=0 SRCON1=0 WPUA=0 WPUB=0 TRISC = 0 PORTC = 0 ProgStart: PORTC.2 = 1 pause 1000 PORTC.2 = 0 pause 1000 goto ProgStart
|
Re: 18F14K50, PORT C as outputs
Are you sure that problems are in portc?
Did you test other port? Maybe you didn't configure oscillator correct, or MCLR pin, etc...
|
Re: 18F14K50, PORT C as outputs
Yes, when I use PORTB everything is fine!
(I can pull the C-outputs still high with a resistor. This gives me the impression that the pins are inputs.)
Last edited by RuudNL; - 1st September 2014 at 15:43.
|
Re: 18F14K50, PORT C as outputs
What value are resistor?
Try to put LED on portc with 1K series resistor, then see what is happening...
|
Re: 18F14K50, PORT C as outputs
The result is (as expected): nothing!
|
Re: 18F14K50, PORT C as outputs
PORTC is probably damaged...
You can try to use LAT registers, but...
|
Re: 18F14K50, PORT C as outputs
I don't think so, because the result is the same with different (new!) 18F14K50's...PORTC is probably damaged...
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks