problem with serial com

[nono2002]

Hello all I'm French and I do a Central I did a program with a pic 18F4620 and 5 DS18B20
scanning work well as display the transmission as long as the PICkit3 plugged if I unplugged the series connection sending anything.
Have you ever encountered this problem and can you help me if needed
best regards

[towlerg]

pullup resistor missing?

[mackrackit]

How are you handling MCLR?

[nono2002]

hello only with a button or a power cycle

[mackrackit]

hello only with a button or a power cycle

Try turning MCLRE to OFF in the configuration.

What version of PBP are you using? It makes a difference on how you do it.

[nono2002]

i put mclre off but it's the same thing, my version of PBP is 2.60
f I unplugged PICkit3 and I reset the prog runs it displays me the correct values ​​on the displays, given series are erroneous if I reconnect the PICkit3 reset this and the serial data is ok

[mackrackit]

My best guess would be a grounding issue. Evidently you are powering the PIC independent from the PC. When the PicKit is connected it changes the potential on the zero rail (ground).

[nono2002]

thank you for directing me to the problem of mass it was indeed a mass between my converter and my plate 'I was thinking more of a problem config 18f thank you again