Can't get the simplest of programs to run using internal osc and just toggling a pin

[Demon]

When you compile, does ALLDIGITAL suggest lines to be added to your code?

Robert

[Szczepaniec]

No, it didn't. Nothing was out of the ordinary as far as I could tell. It didn't before I added the alldigital file to the folder but I did it anyway just in case. I am completely baffled.

[mark_s]

See if this will work.

#CONFIG
 __config _INTRC_OSC_NOCLKOUT & _WDT_OFF & _MCLRE_OFF & _IOSCFS_4MHZ & _CP_OFF & _PWRTE_OFF & _IOSCFS_4MHZ & _BOR_OFF

 #ENDCONFIG

DEFINE OSC 4 ' keep above your code and registers settings
Adcon0 = 0 'disable adc
ANSEL = 0 'gpio all digital
TRISIO = 0 'all outputs except gpio3

 
 do
 'serout2 gpio.5, 396, ["M"]
 high 0
 pause 1000
 low 0
 pause 1000
 loop
 end

Yes, I forgot the High/Low 0 statements are from the old Basic Stamp days.

[Szczepaniec]

No dice. I have tried yet another PIC to make sure I didn't damage the last two and tried a different programmer in the event that was damaged (1 in a million, I know). My gut is that I am missing something oscillator related but cannot figure out what. Thanks for the look at what I have.