Can not decode properly IR remote code.

[gadelhas]

I didn't look at the code, because i'm at work, but you should post your schematic too!

[CuriousOne]

There's nothing much to post in schematic, the receiver is hooked as it should, GND goes to GND, VDD goes to VDD, and OUT is connected to PORTC.4

[ivanrosales]

I never tried NEC protocol before, but Sony SIRC has been worked flawlessly to me and it's very easy to decode with minimal resources, you should give a try:
http://www.picbasic.co.uk/forum/cont...next-project!!

Regards.