Got it all working... Thanks to the "languer" email, it pointed me to the right direction. It works quite well...

Here's are the "tricks":
1. Using the WIZnet software, press the "search" button. It should find the WIZnet board.
2. Again using the WIZnet software, in "local IP" put in an unused IP address in you network. (It will write it into the WIZnet flash)
3. Subnet has to be the same as your network. Same for Gateway.
4.Server IP... You should fill in the device you want to talk to. In my case it was 192.168.1.137
5. Set the two port spots to be the same value. In my case I set them to 9761 (Remember that port 80 is HTTP, port 20 is ftp data, and port 21 is ftp control, unless you're using those formats, stay away from them)
6. I used "mixed mode" where the WIZnet board tries in several ways, to establish communications.
7. Press "settings" to SAVE you data...
8. Test, things should be working...
9. If they are working go back and disable "serial debug", because it will mess up your communications. (Debug came in handy to figure out all this.)
10. Press "settings" to save again...