Hi,

I am hardly getting time to get into the forum and I know I am missing something or the other.

Mincing,

Try to use a resistive load at the output of the bridge and inspect the i/o signals with a scope. Sometimes improver gate drive and/or switch off spike can kill MOSFETs. Please post the schematic and code snippets I will try to help if it is within my scope/knowledge. I am not as active now but you can count on every other member on this forum. Far far better than me.

If you find that you cannot reveal the code/schematic due to commercial problems you can pm me. Again I would try, no commitments.