Hi Sougata ,
thanks a lot for having reply to me.

I do understand that there is no PCB for the project at the moment , but I am still interested in understanding the system operation and I would like to experiment it on my little laboratrory. I am an Italian Radio Ham and the inverter will be used as a backup power source for my radios only.
Is it possible to have a system description, a block diagram and a schematics diagram for me to implement and test the project ?
Is the program written in assembler ?
I will appreciate very much to read back from you.
Thanks in advance.
Regards,
Ambrogio
Iw2fvo[


QUOTE=sougata;108771]Hi,

I do not have a complete design in PBP. My initial design based on 18F452 was a commercial flop so I had to develop one on 16F72/73. Since my initial design there has been a number of improvements in the hardware side too. Like for a 12 volts system I implemented a MOSFET driver with internal charge pump that reduces the switching and conduction loss. Because while the battery is discharging the deep discharge cutoff threshold is generally 10.8 volts so the gates are pumped with merely 10 volts which should drive them into enhancement modes but with a PWM at 20KHz the switching losses are high.

But iw2fvo you are right that there should be complete relevant project to get started. I couldn't do it for babalola though... I definitely have in mind to rig up something for the wiki[/QUOTE]