I figgured it out!!! Or at least I think I did.... none the less it is working now.

I was taking a stab at different things to see what may be causing the PLL not to run.

If you notice, my OSCCON register is set to 11110010.

I changed the OSCCON to = 11110000 and the output on pin 13 is now 125k (actually 124.8k according to the scope)

And thank you for pointing out my lack of defining the oscillator and my lack of any program.

Like I mentioned, I was taking stabs at things I thought might be inhibiting my progress, so I was stripping back everything I could. I guess I went a little too far.

Thank you once again for your assistance. Higher PWM frequencies were a major hurdle in my next design stage and I had to figgure it out. It will allow my project to use much smaller components and be more efficient.

-Albert