Sorry about that. The part is right in one part of the post! It is a 12F1822.

The code is below - I am just trying to get a blinking light at this point(code from this forum). Thanks for your kindness is responding. As far as a schematic, I have 5 Volts, Ground and a connection to an LED on Port A.1 through a 1K resistor.

#CONFIG
_CONFIG _CONFIG1, _CLKOUTEN_OFF & _FOSC_INTOSC & _WDTE_OFF & _PWRTE_ON & _MCLRE_OFF & _BOREN_ON & _IESO_OFF & _FCMEN_OFF
_CONFIG _CONFIG2, _PLLEN_OFF & _LVP_OFF & _STVREN_ON & _BORV_19
#ENDCONFIG
PORTA = 0 ' LED Off
TRISA = 0 ' all outputs
OSCCON = %01101000 ' 4MHz internal
ANSELA = 0 ' all digital

Here:
HIGH PORTA.1
PAUSE 500
LOW PORTA.1
PAUSE 500
GOTO Here

END