Hello together,
i have a problem with powering up a PIC16F1824.
When I apply 5V, the port RA5 gets high for 1µs.
Power Supply is fine, no interruptions - 100n directly on controller supply pin's.
On the port I have connected a FET (resistor 1K from port to gate, 47k from gate to gnd)
I defined port as output in tris register.
Power up timer is enabled.
In a former thread i read, that port and lat settings must be done before tris setting - so
I did this, but the 1µs pulse is still there.
I tried lata and porta - no difference.
I would be thankful for any idea.
best regards
norbert