Erratic behavior on a HPWM on a 16F88

[lerameur]

Alain,
why should it change the data on 'only' if POT changes. It still should give me the same value and not going from 100hz then 2khz !!!
Y I have 256 bits so I SHOULD BE GETTING MAX 256 Hz .......
Like I said the duty cycle works fine, on both AN0 And AN1 !!
I will try the Dont change thing, because i have no more idea
ken

[lerameur]

I am getting 1200 Hz with this HPWM command:
HPWM 1,DutyCycle,350 'channel, dutycycle, frequency
Do not make sense..... My OSCON is good at 8Mhz

[Demon]

Try fixed values just to test setup.

Robert