Erratic behavior on a HPWM on a 16F88

[Acetronics2]

Hi, Ken

1) just modify Duty and Frequency ... ONLY if pots inputs changes.
no need any PAUSE then ...

2) "Frequency" is a Byte ... and the minimum available frequency is ... 489 Hz !!!
rings you a bell somewhere ???



Alain

[Demon]

Do you need PAUSE 100 after setting ADCON0?

Robert

[lerameur]

Alain,
why should it change the data on 'only' if POT changes. It still should give me the same value and not going from 100hz then 2khz !!!
Y I have 256 bits so I SHOULD BE GETTING MAX 256 Hz .......
Like I said the duty cycle works fine, on both AN0 And AN1 !!
I will try the Dont change thing, because i have no more idea
ken

[lerameur]

I am getting 1200 Hz with this HPWM command:
HPWM 1,DutyCycle,350 'channel, dutycycle, frequency
Do not make sense..... My OSCON is good at 8Mhz

[Demon]

Try fixed values just to test setup.

Robert