Quote Originally Posted by Heckler View Post
I would have to spend several hours studying it to make suggestions that you request.

... I was using an LCD with Serial backpack.
Hi Heckler,

I hope it finds you well.

Thank you for your kind replying here.

I really appreciate you in advance for your support.

My suggesstion is to modify your written routine under my Microcode studio and just assign a pin for "R/w". and using LCDIN command for writing in LCD's RAM and so on. Because I should work with usual LCDs. I think I should all these two headers

DEFINE LCD_RWREG PORTE ' LCD read/write pin port
DEFINE LCD_RWBIT 2 ' LCD read/write pin bit
What do you think Sir?

After I received your help, if my suggestion be right, it seems, it would be easy to fix this section. But now, I am hardly busy at something else, a damn PID routine for pressure control. and honestly I cannot focus on anything else. My mind is 100% busy

May I very kindly ask you twice to take a look again at your valuable work and give me some points/remedy for implementing a dot, between 1st and 2nd numbers (from left side)?

I really appreciate you in advance for your support.

I would never forget your kind help.

Best regards,

Andy