Motion profile generator.

[amgen]

H,
Ditto on you always helping everyone. If this isn't too elementary relating to where your at.......

on de-celleration when V_Max reaches to 0...zero, recalculate the ACC (will be de-celerate) val.
if you want the same amount of iterations to de-cel as used to acelerate, at A=10 then 100/10 for 10 loops or A=15 for 100/15 for 6? or 7? loops..............
then subtract present pos (@ V_MAX=0) from desired pos. Thats the actual steps to stopping ??
now use sum of # loops...( sum=loops(loops+1)/2) is new ACC val to loop to 0 (zero) over that many loops (should be +- 1 or 2 from the starting ACC val)
now there will be either 0 or some amount less than A as a final step to stop.
should be a few more lines of code to test and calc.
I think Darrel mentioned re-calc something.
don