Hi
I just a beginner in this field so i know very little on programing
i am trying to program a 12f675 chip, the code compiles with no problem
as soon as i try to program i get the error code i tried erasing but it gives
me the same message the device reads,verifys ,and shows as a blank.
the calibration bit is there it just refuses to burn the chip
i have already used the 16f84A with no problem
i am using the melabs usb programer
the pic basic prog is the PBP silver
the configration is set as
Name: pic config file.JPG Views: 910 Size: 28.7 KB

i also tried to erase the chip without any hex file but i still get the calibration error
anybody have any ideas
Thanks
Raybel