Newbie question on reading port staus

[HenrikOlsson]

Hi,
Just read the Port register:

myValue = PortB

That's it.

/Henrik.

EDIT: Make sure to check and setup stuff like ADCON, CMCON for any pins you're going to use.

[SOTASOTA]

Ah, if only all things in life were this easy!
Thanks!!!

[SOTASOTA]

Now, how do I get the value of the Port if the port is less than 8 bits?

Thanks!

[HenrikOlsson]

Exactly the same way as before.
On a 16F877, for example, PortA is 6bits. Reading it will return a byte with the state of the port pins in the lower 6 bits, the two high bits will always read zero.
PortE on the 16F877 is only 3bits. Reading it will return a byte with the state of the port pins in the lower 3 bits, the upper 5 bits will always read zero.

If you look at the register summary in the datasheet for the 16F877 (or whatever device you're actually using) it's all pretty clear.

/Henrik.

[SOTASOTA]

Yes, that makes good sense. But what if I only use say 4 bits of the PortA port in my code and make the other PortA bits as outputs? Would reading the port give me the correct result?
:-)

[mister_e]

it will also return the state of the output. Nothing hard to solve through a bitwise operation or simply by breading the bits you need.

[SOTASOTA]

Awesome!! THX!!