What / how is the best / easiest way to transfer data?

[Jumper]

Hi,

If you have 4 pins on the 16F628A that is not used already you can have them as outputs and then binary set these pins to represent 0-15 as sound number. The other pic just have to read 4 of it's inpins that are connected to the output from the 628A.

[Ramius]

Thanks Jumper!
Great idea and I only have two pins available

Ed

[Jumper]

2 pins..

Serial data is one possibility.. software out on any pin and then in on the other pic´s HW rx pin.

Or

Pullup in pin A and pin B on the 628A

PinA is set to low.
wait for the other pic to reply "redy to receive" that it will signal with pin B going low.
Pulseout (x ms) depending what sound you play in the 628A
Pulsein for the other pic to read the sound value as a pulse time
Release Pin A so say you are done
pic 2 releases pin B also

if you dont want to use pulse time you can send 1 pulse for sound 1 and 16 pulses for sound 16. and then just count rising or falling edges in PIC2

OR

If you have CCP1 still avaliable you can use that and a double RC network to create an analogue voltage that has 16 different voltage levels. Then you only need one pin and an AD pin on PIC2.