16F877 Flickering LED

[mister_e]

by using end this make your pic to stop or goto lalaland IMHO.

what about

DEFINE OSC 20 ' Set the Xtal frequency to 20mHz

ADCON1 = 7 ' Set Analog pins to Digital.
TRISA = 0 ' Set all PortA Pins as output
RFVDDPin VaR PORTA.3 ' RF Module Power Pin.


Main:
    high RFVDDPin ' Switch RF Module On.
here:
     goto here

also be sure you set the oscillator configuration fuse to HS.

[koossa]

"also be sure you set the oscillator configuration fuse to HS."

How do I do this?

[mister_e]

in your PIC programmer software or into your code
click here to know set fuse into your code

be sure you have a PIC who can handle the 20Mhz clock. PIC16F877-20

[koossa]

Is _XT_OSC for a Crystal, because that is what I am using and that is what the Inc file's default is?

[mister_e]

XT_OSC is used for 4MHZ crystal/oscillator speed. HS_OSC is used for crystal/oscillator over 4MHZ. The default setting is XT_OSC. There's no difference for a PIC to see ceramic resonator or crystal... since it generate pulses.

So in your case you'll have to change it to HS, in the .INC file or as i suggest, comment the config lines in your .INC file and place all fuses setting in your code. Really handy.

[koossa]

Hi Steve

I have done the following:
Edit C:\pbp\16F877.INC, Replace _XT_OSC to _HS_OSC

And edit my code as followings:


Include "Modedefs.bas"

DEFINE OSC 20 ' Set the Xtal frequency to 20mHz
RFVDDPin VaR PORTA.3 ' RF Module Power Pin.

Main:
ADCON1 = 7 ' Set Analog pins to Digital.
TRISA = 0 ' Set all PortA Pins as output
high RFVDDPin ' Switch RF Module On.
here:
goto here
end



But with no luck, it is still flickering?

[mister_e]

is the actual circuit is on a bread board? If so try removing the capacitor around your crystal and post your result. Also, 0.1 uF capacitor sould be as close as you can of the PIC and of the RF module betwenn VDD and GND.

what about if you change your resistor from RF module otput to VDD? If the problem is still there, what about if you remove your RF module?