lol, it seems that way some times , in some ways you tend to solve problems as you post

well since this little pic is doing about 4 diff things at about the same time , as it it talking to currently 16 other RF devices , in sync within a started mesh network, its getting harder to get enough time for each process from a 4Mhz clock , so first of all i had to up the speed to 8Mhz , with all the timming changes to specific routines that was based on 4mhz.

After reading more and doing searches found that pulsin_Max set to the min count time + 5% margin extra of my expected time of the pulsin , allowed it to get to the next command scientifically, when i did not get a valid signal input .

Now to deal with error rates in TX / RX over RF and try and improve on the current poor performance.

more fun to come

Cheers