Maths advise needed

[Megahertz]

My readings from an analog sensor go from 724 to 3604. These valid readings measure angle of 0 - 90 degrees. My initial code is the following:

					If Value<724 then
						Value=0 : Dummy=0 : Goto Jump4 : Endif
					Value=Value-724
Jump4:
					Dummy=Value*9
					Angle=Dummy/288
					Temp=(Dummy*10)/288
					Angle2=Temp DIG 0

I want to display increments of 0.1 but the problem is that it works fine upto the reading of - 6552 (in Dummy variable) as readings after it goes beyond the 16 bit limit.

So as a result

Temp=(Dummy*10)/288

starts overflowing and results after the decimal digit stored in Angle2 start getting messed up. Anyone has any idea on how to deal with this situation please. Thanks

[Megahertz]

Problem Sorted. Taking the remainder and multiplying it by 10 and dividing again.