With the Staples Picture Paper:

I print on them using a lazer Printer
Then iron onto the copper surface
Then peel off
Then rub off the excess paper under water with my thumb
Then dump it into Ferric Chloride.

With the picture Paper and 600 dpi printer I can usually fit a trace in between the terminals of each IC pin. But I have to be extra careful and make sure that the trace is fully etched, sometimes with tight spaceing I have to use a knife to make an extra crease so that the traces get etched correctly.

I think I am going to get a photo etching system, ironing in the hot summer weather while putting as much pressure on the surface as you can is not something I like to do.