Hi, I had Upgraded to PBP3 sometime ago but didn't used it upto now, started using it from yesterday. As expected initial unexpected problems have come up. Following is my configuration, I just need some advise to set it up properly:
1) Upgraded to MPLAB IDE v 8.84
2) PBP Version 3.0.5 compiler
3) Windows 7 operating system
4) 64 Bit operating system
5) While creating project (Toolsite contents say - 'Micro Engineering......(pbpw.exe) BUT Location is set to c:PBP3/pbpx.exe

The code I am writing gives the following error:
Executing: "C:\PBP3\pbpx.exe" -ampasmwin -oq -z -p16F676 "PIR_676_New.bas"
PICBASIC PRO(TM) Compiler 3.0.5.4, (c) 1998, 2012 microEngineering Labs, Inc.
All Rights Reserved.
ERROR: Bad command parameter. -z
BUILD FAILED: Thu May 31 11:36:41 2012