Beginner help!

[AvionicsMaster1]

Well, I sorta agree with the above. Back off a little and try getting a single LED to blink then work your way up. The PBP book talks about some of the peculiarities of the 12F683 so that's a really good place to start.

But, there isn't a PORTB on a 12F683 so the above won't work.

If you look, http://www.picbasic.co.uk/forum/showthread.php?t=14511, here it will explain a few ways to blink an LED.

As far as pin selection, I'd shy away from using pins 3,6 and 7 on the 12F683 if you are doing ICSP. In Circuit Serial Programming (ICSP) allows you to program the PIC without having to remove it from the circuit. If you don't do this you'll have to pull the chip out of circuit, program it then reinsert it in circuit. At any point you can bend a pin or jiggle the circuit. Pin 3 which is Master Clear (MCLR), also pins 6 and 7 which are used for programming Data and Clock. I don't remember which is which. That leaves pin 5 GPIO.2, pin 3 GPIO.4 and pin2 GPIO.5 to put LEDs on. You can attach the Anode of the LED to any of these pins and attach the Cathode to ground.

This link, http://members.shaw.ca/picgroup/Reso...Cadilly-13.pdf, will get you to a paper that really helps when using the 12F683.

Best Wishes

[Demon]

...
But, there isn't a PORTB on a 12F683 so the above won't work.

Gaaaaa, didn't notice the PIC model.

...
You can attach the Anode of the LED to any of these pins and attach the Cathode to ground.
...

Don't forget the current limitting resistor, most use 330ohms.


Side note: I learned basic electronics and PIC programming just by using google. Whenever I was faced with a new component, like a LED, I'd google LED TUTORIAL and found everything I needed to know (anode, cathode, current-limitting resistor, etc).

When I needed extra help, I'd ask on an Electronic 101 forum:
http://groups.yahoo.com/group/Electronics_101/

Robert