Intermittent reset of 16C6440 - possible noise issue

[shahidali55]

A 0.1uF capacitor accross VDD and VSS is always recommended. Just make sure it is located real close to the PIC.
Also, you can add a 5.1V zener diode in between VDD and VSS like below:

[Ramius]

Hi Chris!
The short answer is yes, .1mfd capacitors are very necessary. The techniques for dealing with noise vary based upon the environment and signals in use. If you wish to "dump" your 233Khz then a capacitor of a value based upon frequency in hertz time the capacitance in farads divided by .159 aka Xc= .159/FC. The best choice of capacitors are the tantilum type as the act very much like a diode. Other considerations are things like how your grounds are handled. Typically a "single point" grounding system is best to avoid ground loops which will induce noise and stray voltages. Another tatic is to use a double sided PC board where all unused areas on the board (both sides) become a "ground plane". Lastly is to completely shield the PIC board in a metal box and use what are called "feed thru" capacitors. This of course is for extreme conditions in high emi and rfi environments. It is a good practice to make all ground traces at least twice the size of signal and power traces on a PC board. A "sprinkling" .1 mfd, 10 mfd, 100 mfd, wherever possible will also help. Not knowing what type of 5 volt regulator you are using I would check to ensure you are not using the "switching" type regulator and stick with the known "standard" or analog regulators such as the LM7805. Hope this at least provides some ideas and directions. Best, Ed