problems with I2C.... and ideas why dosent work?

Results 1 to 26 of 26

Threaded View

  1. - 25th April 2005, 23:18 #21
    snood's Avatar
    snood Guest

    Did you find this post helpful? Yes | No

    Default

    i got the datasheet here: http://pdfserv.maxim-ic.com/en/ds/DS1307.pdf

    under the "Slave Receiver Mode (Write Mode)" section of page 11

    also on page 12 the data diagram shws a word address.

    this is highly confusing.

    Snood

    edit: equaly it says: The DS1307 operates as a slave device on the I2C bus. Access is obtained by implementing a START
    condition and providing a device identification code followed by a register address.

    not "serial" but "i2c"

    are you looking at an old version maybe?
    Last edited by snood; - 25th April 2005 at 23:22.
« Previous Thread | Next Thread »

Similar Threads

  1. I2C problems
    By Mad_Labs in forum mel PIC BASIC Pro
    Replies: 2
    Last Post: - 25th September 2005, 06:22

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules