compilation error

[Protech]

Check the code here:
http://www.picbasic.co.uk/forum/showthread.php?t=15960

You are missing the PIC model after DEVICE.

Robert

Thanks for the reply,

And by the way interesting tutorial for me for further and later needs.

But as for now I need this job urgently done for this IR project and I can't seem to get anywhere except with illegal opcode and found label after column 1 (DEVICE).

[mackrackit]

You still do not have
MCLRE

[Protech]

You still do not have
MCLRE

I did! Here it is once again!

[mackrackit]

See if this works. I was not paying attention, you are using PBP 3 ?

#CONFIG
__config _CONFIG1, _INTRC_OSC_NOCLKOUT & _WDT_ON & _LVP_OFF & _CP_OFF & _MCLRE_OFF
#ENDCONFIG

[Bruce]

This should work;

#CONFIG
 __CONFIG _MCLRE_OFF & _INTRC_OSC_NOCLKOUT & _WDT_OFF & _LVP_OFF & _BODEN_OFF & _PWRTE_ON
#ENDCONFIG

And disable case sensitivity in MPASM or make porta PORTA in the assembler part.

[Protech]

Lots of thanks to all contributions!

Now I've got it.


Special thanks to you Bruce, you just saved me a lot of effort.

I was about to call Rentron and report this as I tried another code and had the same problem.

Best regards to all.