Daisy Chaining HSER RX ports

[markscotford]

Thanks everybody, thought I may have run before walking, but seem to have got away with it. Thank you Charles, your post was very helpfull. The boards are all daisy chained with 10 way ribbon cable, linking Power & HSER ports together (with some input protection). The boards are no more than 10cm away from each other. The hardware receiving, software sending idea, switching off modes between communications idea is also helpfull.

Let the heart aches and long nights begin.

[Charles Linquis]

Believe it or not, I used the technique described to communicate over 340' of Belden 24GA unshielded 4 conductor cable (power, ground, transmit, receive).
I was running 9600 baud and I had to reduce the pull-up resistors (1.5K ohms on each board), but it worked. No signal boosting - nothing but two 18F2221's on one end and an 18F8723 on the other.

[Charles Linquis]

Also, the 2221's were running on their internal oscillators, the 8723 was on a crystal.