Hello all,
Sorry to eavesdrop on this thread, but as I am also using an 'F819 in a project, I thought I might learn something.
Having NEVER tried to operate any chip with internal osc. this seemed to answer my unasked question...
So I put that bit of code in, but with defineosc 4 for 4MHz. (the ones I've got)
Pulled the crystal out of my development board and tried it. LCDOUT works beautifully.
All seemed ok until I got to the part where I was debugin-ing some stuff and the section did not work at all. Re-prog'd with XT osc. and all went well again with the crystal in.
There is obviously some other stuff to be added?????
BTW, am debugin-ing at 9600.
Regards,
Peter Moritz,
Up the bush, By the Sea, South Australia.
Bookmarks