Problems with 16F684

[luxornet]

Hi fratello!
I tried to compile but I got :
Error UNTEST~.ASM 440: [235] opcode expected insted of 'error'

[fratello]

Strange ...
I have no errors on compiling...just not work !

[fratello]

With code from post #1, I build this thermo-voltmeter for using in car.
Note : for "I(nside)" I dont have anymore DS18B20 sensor...

[luxornet]

Congratulation, Fratello!
Good work.

[Acetronics2]

Hi, Fratello

I just think ISIS doesn't appreciate you do not wait for DS1820 temp conversion complete to continue running your code ...
not a real problem ( Mikroelektronika lets it as-is in its onewire drivers ... booooo )

in easy words, ....Change

Main :
 OWOut DQ1, 1, [$CC, $44] 
 OWOut DQ1, 1, [$CC, $BE]
 OWIn DQ1, 2, [temperature1.byte0, temperature1.byte1]

for

'*****************************************************************************
' Start temperature conversion
'*****************************************************************************
main:
 OWOut DQ1, 1, [$CC, $44 ]
'*****************************************************************************
' Check for still busy converting 
'*****************************************************************************
waitloop: 

 OWIn DQ1, 4, [Busy]        ' Check for still busy converting
 
 Pause 95         ' Slow Down to actual Conv. time
 
 If NOT Busy Then waitloop
  
'*****************************************************************************
' Read the temperature
'*****************************************************************************
 OWOut DQ1, 1, [$CC, $BE ]
 OWIn DQ1, 2, [temperature1.byte0, temperature1.byte1]
  

.
.
.

you will display the very last correct measurement and not get " 85°C" or junk at power up ...

Alain

[fratello]

Thank You so much for help !
I give up to use "LCD_AnyPin" ... since don't work (see post above, #14) ! I use "classic" hardware, with good results ! And I made one good PCB too...
Best regards !

[luxornet]

You made that PCB in Proteus?