% test

[mackrackit]

ANSEL=%00000000         ' ADC SET FOR DIGITAL 
CMCON=7                 ' COMPARATOR SET FOR DIGITAL
SWITCH_OFF  VAR GPIO.1  ' PUSH BUTTON FOR PUMP OFF
SWITCH_RUN    VAR    GPIO.2  ' PUSH BUTTON FOR PUMP ON  
LED_RUN     VAR GPIO.0  ' INDICATE RUN SIGNAL SENT  
LED_OFF     VAR GPIO.5  ' INDICAT STOP SIGNAL SENT
TX          VAR GPIO.4  ' DATA SEND PIN
BAUD        CON 18030    ' 18030 = 600 BAUD

A % will sometimes be stripped and upper case is turned to lower case. When I code in PBP I have caps lock on so it is not a MCS thing.

EDIT--- in preview the format was all wrong but the post is not so bad??

[cncmachineguy]

doing my own playing here

ansel = % 01001100
ansel = %01001100
ansel =%01001100
ansel=%01001100
ANSEL=%01001100
ANSEL =%01001100
ANSEL = %01001100
ANSEL = % 01001100

should be:
ansel = % 01001100
ansel = %01001100
ansel =%01001100
ansel=%01001100
ANSEL=%01001100
ANSEL =%01001100
ANSEL = %01001100
ANSEL = % 01001100

advanced editor

ansel = % 01001100
ansel = %01001100
ansel =%01001100
ansel=%01001100
ANSEL=%01001100
ANSEL =%01001100
ANSEL = %01001100
ANSEL = % 01001100