maximum oscillator trace length

[mister_e]

never tested the maximum distance but 1-2 inch can be safe. can you solder your crystal or ceramic resonator under your PCB directly on your PIC pins???

[woodygjw]

Steve, you must be on here all the time for me to get an answer that fast!!!

I can put it on the bottom, but I have no components on the bottom now. I think I have room around the display to move it, and still be within 2 inches. I was just curious to what other people may have gotten away with. Thanks again for your quick response!

Greg

[mister_e]

You're welcome.

Steve, you must be on here all the time for me to get an answer that fast!!!

I was in the past before i answer to too many redundant questions and lazy user that don't want to do some forum search and/or home work.

Cheers!

[NavMicroSystems]

Greg,

it also depends on what type of clock source you are using,
Resonator, Crystal, Oscillator (w. TTL Output)

Oscillators are less critical than crystals with external Caps.

If traces get too long you might have problems for the OSC to start up.

I personally would never move a crystal 2 inch away from the MCU.

If it is just the "height" of the crystal causeing the problem:
a Crystal in HC49U-S package is less in height than a PIC in a DIP package,
so you might be able to fit one of these.
SMD crystals are even smaller.

[woodygjw]

Hello Ralph,

Thanks for the response. I am now about 1 inch away so I think all is good. I appreciate the response.

Greg

[Melanie]

Don't forget also that long leads on oscillators also produce heaps of radiated signals... your product might fail CE certification if it's a commercial product.

[woodygjw]

Thanks Melanie for your input. I will not be going through any approvals so I think I am OK. Many thanks to all giving their opinion.

Greg