Newbie help. RGB Led on a PIC10F202

[sayzer]

Your LEDs are conected to Vdd instead of GND.
And GPIO is set to 0, so initially all pins are low at the beginning and thus LEDs are on.
When a PWM cycle is done, the pin stays low again and the LED is still on.

I am guessing Steve forgat to add these in his last posted code above.


Before "pwm ButtonCount,127,100", insert these:

HIGH RED
HIGH GREEN
HIGH BLUE

So the new code will be as below:

MAIN:
 
        IF !SwitchPin THEN                              ' Switch down?
 
                                                        ' - YES
 
                If ButtonCount = 3 THEN ButtonCount = 0 ' - Currently on GP3 (MCLR)?  If so, pass go, claim 200$ 
 
                HIGH RED
 
                HIGH GREEN
 
                HIGH BLUE       
                pwm ButtonCount,127,100                 ' - Light Show
 
                WHILE !SwitchPin : wend                 ' - Spin 'till button is released
 
                pAUSE 50                                ' - arbitrary debouince delay
 
                ButtonCount = ButtonCount + 1           ' - Point to next LED
 
                endif                                   ' 
        GOTO MAIN