Hi guys ,

although this thread is old , it has been helpful in me understanding some of the setup and use of DT instant interrupts , as well as using IOC setting in the 12F683

I do have a question on using IOC and DT_interupt,bas

If the pin for the interrupt is used both as input as well as output , do i need to change anything in setting on the IOC pin (IOC.4=1 - set interupt on change from high on gp4 ) or within DT interrupt.bas when the GPIO its set to output

do i need to turn off or to stop the interrupt routine being called incorrectly if pin is then set to output

Or is the IOC and DT interrupt routines only applicable when its GPIO is an input

regards

Sheldon