Hello folks

I'm dabbling 12LF1822 which only has three timers available TMR0, TMR1 & TR2.

I need a 16 bit timer fpor capactive touch so that'll be TMR1 (to count the output from the CPS module) & timer2 is needed for the capacitive touch 'timebase'.

therefore that only leaves only Timer0 for HPWM.

I've used the following define...

DEFINE HPWM1_TMR 0

....but not sure what the limitations are if associating Timer0 with HPWM?

I'm ideally looking for HPWM in the 40-50khz range ....is this gonna be possible here? (the manual says no higher than 32767Hz is do-able .....are there any workarounds possible...if not, under what conditions is that 32,757 reachable...I'm running the OSC at 8MHZ internal)