Quote Originally Posted by HenrikOlsson View Post
Am I right in that you have the SPI pins on the ConnectOne module connected to the MSSP module on the AMICUS18 so that it can use that interface instead of the bit-banged serial?
As I responded earlier, all pins are accessible and the user can route them as desired. However, I need to add the caveat that they should only be connected to a 3V3 device. While I have added the LDO and have added circuitry needed for level conversion on the TX, RX & RESET, I will not be adding level conversion to the other lines, not even SCL & SDA used for the I2C bus so these features will need a 3V3 system. There's just not enough real estate on these boards for the additional circuitry.