Using the Arduino Ethernet shield with AMICUS18 (Joint forum project?)

[VaGyver]

I think that i understood it (the issue about dividing the time by 2).

What i will do is that i will simply rotate each byte by 2 to the right individually. So it will be divided by two. The DHCP_LeaseTime[3] by 2, then the DHCP_LeaseTime[2] by 2, ........ lastly the DHCP_LeaseTime[0].
I think it will have the same result.


For the dynamic variables:
I am not sure that i understood correctly what you are saying, but what i exactly do is placing the following html command. With this, the web page gets refreshed each 5 seconds.

Str Buffer="<meta http-equiv=\"refresh\" content=\"5\">",13,10,0 'refresh every 5 seconds
GoSub PutStringInTXBuffer


You could select other time too, if you wish.
So, the client (the person who sees your web page) will load again all the web page with the new variables (every 5 seconds). This is not quite effective since, sometimes, it makes a flashing on the page. But the data get refreshed correctly.
There is also an other (more effective) way to do that (in order to avoid the flashing), with xml requests, but i am yet enough familiar with it.