Using the Arduino Ethernet shield with AMICUS18 (Joint forum project?)

[Heckler]

good write up on the modification Henrik,

I have always dreamed of setting up a little web connected interface for home automation type stuff. This seems like it would be a great place to start... especially if it was based on PICbasic pro.

I guess I better get me one of those amicus's and an ethernet shield.

[HenrikOlsson]

You can definitely use the EM202 or one of Tibbos other modules, or you can use theXPort or perhaps something from Netburner, or maby the EZWebLynx or the DigiConnectMe. Or you might want to go "low level / hardcore" and use the ENC28J60 or ENC424J600 or some other ethernet control and write the TCP/IP stack yourself. There are many ways of doing it.

But this thread wasn't supposed to be about other ways of doing it, it was meant to be about how to do it with the Wiznet W5100 which is what is being used on the Ethernet shield.

By the way, I've got PING working....and I've got to a point where I can see the HTTP Get request in the W5100 Receive memory buffer :-)

/Henrik.