PIC 16f877a

[mister_e]

Various thing may do that, but I would suggest to enable the Brown-Out detect, and Power On Timer config fuses and see how better/worst it is from there.

[aratti]

The schematic could help to understand better. Can you post it?

Cheers

Al.

[CipiCips]

HI

here is the schematic:



I have tried to enable BOD, and these are results:

When I insert PIC into Board and turn the switch on, program run correctly, but when I turn the switch off and let it be offline few min, then when I turn it on it want work, BUT when I turn OFF the switch and Take out PIC from board and Plug him back to board, and turn the switch ON program runs correctly ?
So every time I Remove it from board and plug him back program works

[mister_e]

Slow slope power-on/Power off PSU behaviour.

You want to test the BOR, PD bits at the start of the program then.

Check the datasheet for STATUS, PCON register

[CipiCips]

I am lil bit confused now ?? how to chack that ?

[aratti]

What is the state of all the unused and floating pins ? Are they outputs or inputs ?
If you have them set (tris setting) as input then turn them into output and clear them to zero.

Never leave inputs floating without pullup or pulldown.

Cheers

Al.

[CipiCips]

Hmm

so I should put all my pins (register E,C ect.) that I am not using to OUTPUT

[Archangel]

Hmm

so I should put all my pins (register E,C ect.) that I am not using to OUTPUT

Setting them to low outputs gives them a low impedance potential. As inputs with a high impedance potential they are subject to "Stray capacitance" electric fields which typically have relatively high voltage and very low current available. If you need them as inputs, you would either enable weak pullups, tie them to either ground or VDD with resistors depending on your need, again lowering their input impedance to several hundred to a few thousand ohms, exception: If you WANT to use them as capacitor plates, maybe a touch sensor.
You might find some value here:
http://www.electronic-engineering.ch...box_keypad.pdf
http://www.electronic-engineering.ch...g/box_dbg.html

I like how they use a comparator to trigger an interrupt to check the keyboard register.