MicroCode Studio oddity...

[mtripoli]

No, it's weirder than that...

As I continue to code I see that other pin/labels are not auto-correcting. I'm coding for a PIC16F1946 64 pin device. Labels attached to PORT A,B,C,D,E.0-6 and G all auto-correct. E.7 and all of PORTF do not. Is this an indication of a deeper problem? Odd that one pin on a port and an entire port is not "recognized". I'm coding and compiling as I go (I don't have the hardware ready yet) so I don't know if the actual pin works yet.

***** ORIGINAL POST *****
I have a bunch of variables in my code. They're all in uppercase letters. While typing if I type one of the labels in lowercase it will auto-correct to uppercase, except for one. Usually this is a good check that the label is wrong. But in this case it is correct, just not auto-correcting. Code compliles just fine... anyone else seen this?

Thanks.