MicroCode Studio oddity...

[HenrikOlsson]

Hi,
This is what I use from within MCSP:

-P$target-device$ -F$hex-filename$ -E -M -B -L -V5

And the exutable is called PK3Cmd.exe which I don't think is the same as the standalone programmer software for the PK3.

The -V5 is said to specify the voltage output on the Vdd line by the PICKit3 so be careful if you're using a 3.3V PIC etc.

/Henrik.

[mtripoli]

Thanks Henrik, that did the trick.

[Demon]

I also get the auto-correct oddity in MCSP since I updated (I had an old version).

(system specs below)