16F777 at 115200 baud

[cpayne]

Thanks for all the help. I understand fosc/4, but i am not sure Serout2 or serin2 uses that. I define the osc speed up top. I have to use 10000000 to get 19200 or 38400 to work with no issue. the debug may work for outgoing, but eventually i will need incoming... I am currently laying out another board with a 2 UART chip since hserin and hserout work fine at 115k and a 20mhz osc, but i would really prefer to use my existing chip.

-Charlie

[HenrikOlsson]

OK, you're probably correct then, sounds a bit strange though.... Anyway, if DEBUG does indeed work for the output then DEBUGIN will most likely work for the input - as long as you don't need to change pin or baudrate at runtime.

/Henrik.

[Charles Linquis]

Debug is much more "light weight", since the parameters are calculated at compile time, not every time the routine is called.

It works fast in both directions.